Manual

Theseparametersallrelatetothecontrolofthesolenoidvalve.
TheDWELLparametersetstheamountoftimethatthesolenoidisenergizedandthereforetheamountofgasthatisreleased
witheachshotoftheGEO3.1.Settingthisparametertoolowwillresultinlowvelocityshotsand/orexcessiveshottoshot
velocityfluctuations.SettingtheparametertoohighwillsimplywastegasandmaketheGEO3.1louder.TheDWELLcanbe
setbetween0.0and30.0milliseconds.Thefactorydefaultsettingcannormallybereducedafterafewthousandshotsasthe
GEO3.1‘beds-in’.
“Firstshotdropoff”isareductioninvelocityofthefirstshotfiredafteranextendedperiodofnotfiringandiscausedbythe
stictionbetweendynamico-ringsandthesurfacesthattheyareincontactwith.Inordertocompensateforfirstshotdrop-off
thisparametercanbesettoaddextratimetotheDWELLparameterforthefirstshot.Thisparametercanbesetbetween0.0
and5.0milliseconds.
ThetimethathastoelapsebeforetheFSDCOMPisappliedtoashotfollowingapreviousshot.Thisparametercanbeset
between00:00and04:00minutes.

TiMiNG MENU
DWELL PARAMETER
FSD COMP PARAMETER
FSD DLY PARAMETER
ADVANCED SETUP 33