Manual

THE SOUND iNDiCATOR
THE TRiGGER DETECTiON iNDiCATOR
Inorderforthetriggertobesuccessfullyoperateditmustfirstbereleasedandthenpulled.Thetriggerdetectionindicator(TDI)isusedto
indicateeachofthepossibletriggerstates.
FromthefactorytheGEO3.1willhavetheOPTOsensorenabled.The
micro-switchcanbeenabledfromtheHardwaremenu(seepage37).
ThesoundindicatorontherunscreenisusedtoconveyiftheSoundparameterintheHardwaremenu(page37)isswitchedonoroff.
Therearetwopossibleconditionsthatcanbeindicated:
SOUNDENABLED
Thesoundparameterisenabled.TheGEO3.1willmake
soundswhenswitchedonandoffandwhenthegame
timeralarmsortimesout.
SOUNDDISABLED
Thesoundparameterisdisabled.TheGEO3.1willnot
makeanysounds.
MICRO-SWITCHSELECTED,NOTACTUATED
TheGEO3.1isconfiguredtousethemicro-switchto
detecttriggerpulls.Themicro-switchisnotcurrently
actuated,i.e.thetriggerisreleased.
MICRO-SWITCHSelected,ACTUATED
TheGEO3.1isconfiguredtousethemicro-switchtodetect
triggerpulls.Themicro-switchiscurrentlyactuated,i.e.
thetriggerispulled.
OPTOSENSORSELECTED,READINGABOVEPULL
POINT
TheGEO3.1isconfiguredtousetheOPTOsensorto
detecttriggerpulls.TheOPTOsensoriscurrentlyreading
abovetheOPTOpullpoint,i.e.thetriggerisconsidered
‘pulled’.
OPTOSENSORSELECTED,READING0%
TheGEO3.1isconfiguredtousetheOPTOsensorto
detecttriggerpulls.TheOPTOsensoriscurrentlyreading
0%,i.e.thetriggerisfullyreleased.
OPTOSENSORSELECTED,READING100%
TheGEO3.1isconfiguredtousetheOPTOsensorto
detecttriggerpulls.TheOPTOsensoriscurrentlyreading
100%,i.e.thetriggerisfullydepressed.
OPTOSENSORSELECTED,READINGBELOWRELEASE
POINT
TheGEO3.1isconfiguredtousetheOPTOsensorto
detecttriggerpulls.TheOPTOsensoriscurrentlyreading
belowtheOPTOreleasepoint,i.e.thetriggerisconsidered
‘released’.
OPTOSENSORSELECTED,READINGMID-RANGE
TheGEO3.1isconfiguredtousetheOPTOsensorto
detecttriggerpulls.TheOPTOsensoriscurrentlyreading
somewherebetweentheOPTOreleasepointandthe
OPTOpullpoint,i.e.thetriggerishalfdepressed.
24 USiNG THE GEO3.1