Manual

SecurelyattachabarrelblockingdevicesuchastheEclipseBarrelSock
1

(suppliedwiththeGEO3.1)tothemarkerasshownin FIGURE13A .

TurnofftheGEO3.1electronicsbyholdingdownthe
buttononthe
backoftheframe.Whenthescreenturnsoffandthemarkerspeaker
emitsthe‘off’tone(iftheSoundparameterisenabled),themarkerhas
beenturnedoff
(SEEFIGURE13B) .

WiththeGEO3.1pointingawayfromyou.De-gasthemarkerby
depressingthePOPSlatchbuttonallowingthebonnettoslideforward
andventair.OnlywhenthePOPShasfullydegassedtheGEO3.1marker,
unscrewandremovetheairsystem
(SEEFIGURE13C) .

Opentheclampingleveronthefeedtubeandslackenoffthesprocket
screwifnecessaryonthefeedtube.Carefullypulltheloaderoutofthe
feedtube
(SEEFIGURE13D) .
Lookingdownthefeedtube,checktoseeifthereareanypaintballsstill
inthebreech,ifthereare,turnthemarkerupsidedownwhilestillkeeping
thebarrelfacingawayfromanypersonswithinfiringrangethentipout
anypaintballswithinthebreech
(SEEFIGURE13E&13F) .
Nextremovethebarrelblockingdevice,andunscrewthebarrel
(SEE
FIGURE13G) .Removeanypaintballswithinthebarrel.TheEclipse
GEO3.1hasnowbeenunloadedandisreadyforstorage.






1
Instruction on using the Eclipse Barrel Sock can be found on the Eclipse Barrel Sock warning
label.
UNLOADiNG THE GEO3.1
ALWAYS KEEP THE ECLIPSE GEO3.1 POINTED IN A SAFE
DIRECTION AND ENSURE ALL PERSONS WITHIN RANGE
CONTINUE TO WEAR FACE PROTECTION, UNTIL MARKER
IS COMPLETELY UNLOADED AND SAFE.
WARNING
FIG13A
FIG13C
FIG13E
FIG13F
FIG13B
FIG13D
FIG13G
20 USiNG THE GEO3.1