Manual

EveryGEO3.1comescompletewithanEclipsepushonpurge
system(POPS)whichprovidesadirectconnectionforapresetair
system.BeforescrewinganairsystemintothePOPSensurethatthe
bonnetisdisengagedinitsforwardposition
(SEEFIGURE10A) .Ifthe
bonnetisengaged,depressthelatchbuttonandslidethebonnet
forward.

CheckthatthePOPSretainingscrewsaretight.IfthePOPScanbe
movedontheframethescrewsaretoolose.Usea5/32”hexkeyto
tightenthescrews.

ScrewthepresetairsystemintothePOPS
(SEEFIGURE10B) sothat
thebottlescrewsinallthewayandistight.
PullthebonnetbackwardsallowingthePOPSpintodepressthe
valvepininthepresetairsystemcausingtheGEO3.1tobecome
pressurised(providingthatthereissufficientairinyourtank)
(SEE
FIGURE10C) .Whenthebonnethasbeenpulledbackfarenoughit
engageswiththePOPSbody.
1,2


YouhavenowinstalledapresetairsystemontoyourGEO3.1.















1
High, mid and low pressure output preset air systems can be used with the GEO3.1, providing
the GEO3.1 has the SL4 inline regulator originally supplied with the marker.
2
The force needed to engage the bonnet may vary depending on the output pressure and
internal design of the air system being used.
CONTiNUED
FIG10A
FIG10B
FIG10C
USiNG THE GEO3.1 17