Manual

CHECKTHATTHEGASTHROUGHPIPEASSEMBLY
ISCORRECTLYINSTALLEDBEFOREINSTALLINGA
PRESETAIRSYSTEM.
SEEPAGE15FORINSTRUCTIONONINSTALLINGTHE
GASTHROUGHPIPEASSEMBLY.
MAKE SURE THE MARKER IS TURNED OFF WITH A BARREL BLOCKING DEVICE INSTALLED AND THAT NO PAINTBALLS
ARE IN THE MARKER OR LOADER BEFORE INSTALLING AN AIR SYSTEM.
COMPRESSED AIR AND NITROGEN SYSTEMS CAN BE EXTREMELY DANGEROUS IF
HANDLED OR USED INCORRECTLY.
ONLY USE AN AIR SYSTEM CERTIFIED FOR USE WITHIN THE TERRITORY OF INTENDED USE.
THE GEO3.1 CANNOT BE USED WITH CO2. ONLY USE COMPRESSED AIR OR NITROGEN.
NEVER ADD ANY LUBRICANTS OR GREASES INTO THE FILL ADAPTER OF THE AIR SYSTEM REGULATOR
ENSURE THAT ALL SCREWS ARE TIGHTENED AND NO PARTS ARE LOOSE BEFORE INSTALLING AN AIR SYSTEM.
DO NOT PRESSURISE THE GEO3.1 WITHOUT THE BOLT SYSTEM CORRECTLY INSTALLED, AS HIGH PRESSURE GAS WILL
BE EMITTED.
DO NOT INSTALL A COMPRESSED AIR SYSTEM OR LOAD PAINTBALLS INTO THE GEO3.1 UNTIL YOU FEEL COMPLETELY
CONFIDENT WITH YOUR ABILITY TO HANDLE THE MARKER SAFELY AND RESPONSIBLY.
ALWAYS RELIEVE ALL RESIDUAL GAS PRESSURE FROM THE GEO3.1 BEFORE UNSCREWING THE PRESET AIR SYSTEM.
WARNING
iNSTALLiNG A PRESET AiR SYSTEM
IF YOU ARE AT ALL UNSURE ABOUT INSTALLATION OF THE GAS THROUGH PIPE PLEASE CONTACT YOUR NEAREST
SERVICE CENTRE
16 USiNG THE GEO3.1