Manual

EveryGEO3.1comescompletewithanEclipseShaft4barrel(see
page70).TheboresizeoftheShaft4barrelbackisengravedonthe
barrelbackjustinfrontofthebodythreads.
ToinstalltheShaft4barrel,firstlyscrewthebarreltipandbarrel
backsectionstogether.ThethreadsontheShaft4barreltipare
reversethreaded.Toscrewthetwosectionstogether,withthebarrel
pointingawayfromyou,turnthebarreltipinaclockwisedirection
(SEEFIGURE6A) .
WhilepointingtheGEO3.1markerinasafedirection,insertthe
assembledShaft4barrelintothefrontoftheGEO3.1bodyandscrew
theShaft4barrelintotheGEO3.1(inacounter-clockwisedirection).
ContinuetoscrewtheShaft4barrelintotheGEO3.1bodyuntilthe
barrelbecomessnuginthebody
(SEEFIGURE6B) .DONOTover
tightenthebarrel.
InstallabarrelblockingdeviceoverthebarrelsuchastheEclipse
barrelsock
1
suppliedwiththeGEO3.1 (SEEFIGURE6C) .
2
Youhavenow
installedthebarrel.







1
The Eclipse Barrel Sock that comes with the GEO3.1 may differ from that pictured in this
manual.
2
Instruction on using the Eclipse Barrel Sock can be found on the Eclipse Barrel Sock warning
label.
iNSTALLiNG A BARREL
MAKE SURE THE MARKER IS TURNED OFF AND THAT NO
PAINTBALLS ARE IN THE MARKER OR LOADER BEFORE
INSTALLING A BARREL.
WARNING
FIG6A
FIG6B
FIG6C
USiNG THE GEO3.1 11