Manual
CONTINUED
Clean and check the condition of the single internal
006 NBR90 o-ring in the front of the OOPS insert, replace
if necessary SEE FIGURE 15.5. Lubricate all three of these
o-rings liberally using Eclipse Grease SEE FIGURE 15.6.
Replace the OOPS insert into the OOPS body ensuring
that the o-ring end goes in rst, pushing it into place SEE
FIGURE 15.7
.
Lubricate the narrow end of the OOPS pin with a smear
of Eclipse Grease and push the pin, narrow end rst, into
the OOPS body so that it sits in the OOPS insert and pokes
through the front of the OOPS body SEE FIGURE 15.8.
Screw the OOPS knob back onto the OOPS body until only
a couple of threads are showing SEE FIGURE 15.9.
Reconnect the macroline hose to the tting on the OOPS
body SEE FIGURE 15.10.
You have now successfully cleaned and maintained your
On/O purge system.
WARNING: IF YOU ARE AT ALL UNSURE AT PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
6971
FIG 15.10FIG 15.9
FIG 15.8FIG 15.7
FIG 15.6
FIG 15.5
64.
MAINTENANCE