Manual

CONTINUED
Take the Prop Shaft and having cleaned o any old grease,
paint or debris, apply Eclipse Grease to the large rear o-ring
and the threads (SEE FIGURE 11.10) and also to the 14x2
o-ring near the front of the Prop Shaft (SEE FIGURE 11.11).
Take the Bolt and having cleaned o any old grease, paint
or debris, apply a light lm of Eclipse Grease to cover the
front end of the bolt and also the internal rear bore of the
bolt SEE FIGURE 11.12. Apply a coat of Eclipse Grease to
the 2 external Bolt o-rings near the centre of the bolt SEE
FIGURE 11.13.
Remove excess Eclipse Grease by wiping o with nger.
Aim to apply only a very thin lm of grease to the
components maintained, as excess grease can cause poor
performance.
Slide the Bolt onto the Prop Shaft (SEE FIGURE 11.14) and
slide the Can over the Bolt and push into place until the
Can touches the Prop Shaft Back Cap (SEE FIGURE 11.15).
Finally wipe any excess Eclipse Grease o the o-ring on the
head of the bolt and insert the complete Bolt Assembly
into the marker body (SEE FIGURE 11.16).
Either by hand or using a 1/4” hex key, screw the Bolt
Assembly into the marker body (SEE FIGURE 11.17).
1
If inserted by hand the Prop Shaft and Bolt can be accessed
and maintained by hand in future.
1
DO NOT over tighten the Bolt Assembly.
WARNING: IF YOU ARE AT ALL UNSURE AT PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
6971
FIG 11.16
FIG 11.17
FIG 11.12
FIG 11.13
FIG 11.14
FIG 11.15
FIG 11.10 FIG 11.11
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
53.
MAINTENANCE
MAINTENANCE
QUICK GUIDE