Manual
MAINTAINING THE BOLT
SYSTEM
Using a 1/4” hex key or ngers unscrew the Prop Shaft from
the marker body SEE FIGURE 11.1. Once the threaded
section is free from the threads in the marker body and
turning freely, pull the Prop Shaft from the marker body.
Place a nger down the feed neck and push the Bolt free
from the Can inside the body by pushing it backwards SEE
FIGURE 11.2.
Once the Bolt is free from the Can, insert
a nger into the rear of the marker and remove the bolt
completely SEE FIGURE 11.3.
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
FIG 11.2
FIG 11.4FIG 11.3
FIG 11.1
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
51.
MAINTENANCE
MAINTENANCE
QUICK GUIDE