Manual
CONTINUED
Remove the rubber Detent and using a dry cotton bud
clean the Detent and it’s location point in the Geo2 Body.
1
SEE FIGURE 9.4 Replace the Detent back into the Geo2
body and place the BBSS back into the designated slot in
the body SEE FIGURE 9.5. Ensure that the sensor is face
down in the body i.e. looking into the breech.
2
Replace the sensor cover and using a 5/64" hex key, replace
the Bream Beam Sensor cover retaining screw to hold the
sensor cover in place SEE FIGURE 9.6.
Repeat the procedure for the opposite side of the Geo2.
You have now cleaned your Break Beam Sensor System.
1
When cleaning the Break Beam sensor system inspect the
condition of rubber nger detents and replace if necessary.
2
Ensure that the receiver sensor (indicated by a red mark & red heat
shrink) is located on the right-hand side of the marker body.
WARNING: IF YOU ARE AT ALL UNSURE AT PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
6971
FIG 9.6
FIG 9.5
FIG 9.4
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
47.
MAINTENANCE
MAINTENANCE
QUICK GUIDE