Manual

TRAINING
THE TRAINING PARAMETER
The TRAINING parameter is used to select
Training mode. In Training mode the Geo2
will function exactly the same as normal but
with two important dierences:
1. The solenoid valve is not driven so the
bolt does not move and does not release a
burst of air. Instead the beeper will sound
for each pull of the trigger. This simulates
the ring cycle without wasting air and generating lots of
noise.
2. The BBSS is overridden so that the Geo2 can cycle
without paint. The centre of the BBSS indicator changes to
a ‘T’ to indicate that Training mode is enabled.
The TRAINING parameter choices are as follows:
> OFF: Training mode is disabled and the Geo2 functions
normally.
> ON: Training mode is enabled.
> CANCEL: Cancel editing and leave the parameter
unchanged.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
43.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE