Manual

SETTING UP YOUR GEO2
Before you can begin to use your Geo2, you will need to
attach an air system and a paintball loader.
INSTALLING A PRESET AIR
SYSTEM
Every Geo2 comes complete with an Eclipse On/O Purge
System (OOPS) which provides a direct connection for
a preset air system. Before screwing the air system into
the OOPS ensure that the On/O knob is wound out
approximately half way SEE FIGURE 4.1. Be careful not to
unscrew the On/O knob too far as it will come completely
o the OOPS. If this happens, replace the On/O knob
by screwing it back onto the OOPS body in a clockwise
direction.
1
Screw the preset air system into the OOPS SEE FIGURE
4.2
so that the bottle screws in all the way and is tight.
Slowly turn the On/O knob in a clockwise direction
allowing the OOPS to depress the pin of the preset air
system causing the Geo2 to become pressurised, providing
that there is sucient air in your tank SEE FIGURE 4.3.
You have now installed a preset air system onto your Geo2.
1
High, mid and low pressure output preset air systems can be used
with the Geo2.
WARNING: ALWAYS RELIEVE ALL RESIDUAL GAS
PRESSURE FROM THE GEO2 BEFORE UNSCREWING THE
PRESET AIR SYSTEM.
WARNING: THE GEO2 CANNOT BE USED WITH CO2,
IT CAN ONLY BE POWERED BY COMPRESSED AIR OR
NITROGEN.
FIG 4.3
FIG 4.2
FIG 4.1
WARNING: MAKE SURE THE MARKER IS TURNED OFF
AND THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING AN AIR SYSTEM.
16.
USING yOUR GEO2