Manual

SWITCHING ON THE GEO2
To switch on the Geo2 press the button twice in quick
succession, referred to elsewhere in this manual as ‘double-
clicking’. The Geo2 can also be switched on by pushing and
holding the button FIGURE 3.1.
SWITCHING OFF THE GEO2
Press and hold the button until the display shows TURN
OFF.
Release the button and re-press it to turn o the
Geo2. Alternatively double click the button to enter the
menu tree then press to turn o the Geo2.
1
FIRING THE GEO2
Pull the trigger to re the Geo2. The entire ring sequence
is controlled electronically by the Geo2 circuit board,
enabling any user to easily achieve high rates of re.
THE GEO2 CIRCUIT BOARD
There are four sockets on the Geo2 circuit board; the
BBSS connector A , the Geo2 solenoid connector B ,
the auxiliary socket to which third party products such
as loaders and RF transmitters can be connected using
the relevant wiring harness C and the Expansion Board
Socket which connects the Eclipse E-Portal USB Daughter
Board to the Geo2 D SEE FIGURE 3.2.
2,3
1
The double clicking feature is user selectable, factory default is set
to on. It can be turned o using the Double Click parameter in the
Hardware Menu (see page 42).
2
The Auxiliary socket is turned on and o manually via the AUX
OUT parameter in the hardware menu on page 42.
3
Eclipse E-Portal sold separately.
FIG 3.2
FIG 3.1
C
A
D
B
14.
QUICk SET-UP