Manual

THE PUSH ON/OFF PURGE
SYSTEM POPS
Having disconnected the Macroline hose from the tting
on the POPS Body, fully depress the Latch Button then
slide the Bonnet forward while continuing to depress Latch
Button SEE FIGURE 15.1.
When the Bonnet is in the forward position SEE FIGURE
15.2
remove the Latch Button and Spring from the Bonnet
SEE FIGURE 15.3 then slide the Bonnet o the POPS Body
SEE FIGURE 15.4. Be careful not to lose the spring.
Carefully slide the Push Rod out from either side of the
POPS Body, taking care not to lose the two o-rings on the
Push Rod SEE FIGURE 15.5.
Clean o any dirt, debris or moisture from the Bonnet, the
POPS Body and the Latch Button SEE FIGURE 15.6.
Remove the POPS Insert Assembly using a 5/32” hex key
SEE FIGURE 15.7
. Remove the POPS Pin from the POPS
Insert.
Clean and check the condition of the 007 NBR70 o-ring on
the outside of the POPS Insert, replacing as necessary SEE
FIGURE 15.8
.
FIG 15.2
FIG 15.3
FIG 15.1
FIG 15.4
FIG 15.8FIG 15.7
FIG 15.6
FIG 15.5
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
CONTENTS
ORIENTAT ION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
63.
mAINTENANCE
MAINTENANCE
QUICK GUIDE