Manual

TSLOT MOUNTING
SYSTEM
The Geo2 utilises a T-slot arrangement to mount the OOPS
to the bottom of the frame. The T-slot is an improvement
over the dovetail mounting system found on most
paintball markers, and is much more able to withstand the
rigours of modern tournament paintball.
STRAIGHT HOSE FITTINGS
The straight hose ttings found on the Geo2 DO NOT
require ‘Loctite’ to secure them on the marker. These are
secured by the capture o-ring on the end of the tting.
Only use a 3/32” hex key in the designated hole inside the
tting to remove or re-attach the tting. When re-attaching
the ttings DO NOT apply too much force or the threads on
the tting/receiving part may be damaged (remember to
stop when you meet resistance).
MACROLINE HOSING AND
ELBOWS
To aid the longevity of your Macroline hosing, it is very
important to remove it from (and install it back into) the
ttings in the correct manner:
Pull back the collet section of the hose tting and keep the
collet depressed. Pull the Macroline hose out of the hose
tting and release the collet.
Before installing the Macroline hose into the hose tting
ensure that the end has been trimmed correctly to ensure
a tight t in the hose tting.
TSLOT
MOUNT
IF YOU EVER REMOVE THE MACROLINE HOSE FROM
THE FITTING, ALWAYS CHECK THE CONDITION OF
YOUR MACROLINE HOSING AND IF IT IS WORN OR THE
WRONG LENGTH REPLACE IT IMMEDIATELY.
18.
USING yOUR GEO2