Manual

SWITCHING ON THE GEO2
To switch on the Geo2 press the button twice in quick
succession, referred to elsewhere in this manual as ‘double-
clicking’. The Geo2 can also be switched on by pushing and
holding the button FIGURE 3.1.
1
SWITCHING OFF THE GEO2
Press and hold the button until the display shows “TURN
OFF
”. Release the button and re-press it to turn o the
Geo2. Alternatively double click the button to enter the
menu tree then press to turn o the Geo2.
1
FIRING THE GEO2
Pull the Trigger to re the Geo2. The entire ring sequence
is controlled electronically by the Geo2 Circuit Board,
enabling any user to easily achieve high rates of re.
THE GEO2 CIRCUIT BOARD
There are four sockets on the Geo2 Circuit Board; the BBSS
socket A , the Geo2 Solenoid socket B , the Auxiliary
socket to which third party products such as loaders and
RF transmitters can be connected using the relevant
wiring harness C and the Expansion Board socket which
connects the Eclipse E-Portal USB Daughter Board to the
Geo2 D SEE FIGURE 3.2.
2,3
1
The double clicking feature is user selectable, factory default is set
to on. It can be turned o using the Double Click parameter in the
Hardware Menu (see page 42).
2
The Auxiliary socket is turned on and o manually via the AUX
OUT parameter in the Hardware menu on page 42.
3
Eclipse E-Portal sold separately (see page 65).
FIG 3.2
FIG 3.1
C
A
D
B
CONTENTS
ORIENTAT ION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
15.
QUICk SET-UP
QUICK SET-UP
QUICK GUIDE