User's Manual

the ShAft4 bArreL
A
B
D
C
The Eclipse Etha comes as standard with an Eclipse Shaft4 barrel .
1,4
The barrel screws into the front of the Etha using a right hand thread meaning
that if you hold the Etha pointing away from you the
barrel screws into the body in a
counter-clockwise direction.
2
The barrel comprises of two parts, a barrel back
A
and a barrel tip
B
. The two
parts are joined together with a
left hand thread meaning that if you hold the barrel ,
with the back section nearest you, the
barrel tip screws in a clockwise direction.
On the
barrel back there is a 016 NBR 70 o-ring
C
which prevents the Shaft4 barrel
from vibrating loose from the
Etha body when the marker is fired. There is also a 016
NBR 70 o-ring on the front of the
barrel back
D
helps with alignment when the two
barrel sections are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
1
The bore size of your Shaft4 may vary according to the
model of Etha that you have.
2
The Etha will only accept COCKER threaded barrels. Do
not use any other type of barrel thread.
3
The Eclipse Shaft4 tip and back barrel sections are not
interchangeable with older version Shaft tip and back
barrel sections (including Shaft3 barrel kits).
4
The model of barrel accompanying your Etha may differ
from that stated in this manual.
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SPARES & ACCESSORIES
INDEX
QUICK SET-UP
CONTENTS
ORIENTATION
13
ORIENTATION
QUICK GUIDE