Manual
SWITCHING ON THE ETHA
At the rear of the frame is the navigation console. Press
and hold the select button
(SEE FIGURE 1A).
Release the select button
when the LED lights up
and your Etha will begin its power up sequence.
SWITCHING OFF THE ETHA
Press and hold the select button
. Release the
select button
when the LED on the navigation
console turns red. The LED will then extinguish and
the Etha will turn off.
The Etha has a built in auto-off timer of 20 minutes.
If the trigger is not pulled or the select button
is
not pressed for 20 minutes then the Etha will power
off.
FIRING THE ETHA
If the Break Beam Sensor System is enabled (the BBSS
is automatically enabled on power up) and there is
a paintball in the breech, pulling the trigger will fire
the Etha. If the Break Beam Sensor System (BBSS) is
disabled, the Etha will fire whenever the trigger is
pulled, regardless of whether a paintball is in the
breech or not.
The entire firing sequence is controlled electronically
by the Etha circuit board and solenoid valve, enabling
any user to achieve high rates of fire easily.
THE ETHA CIRCUIT BOARD
There are three sockets on the Etha circuit board, the
BBSS connector
A
, the solenoid valve connector
B
and the micro-switch connector
C
.
There is a tournament lock button
D
towards the
base of the board. Information on the tournament lock
button functionality can be found on page 29.
(SEE
FIGURE 1B).
PLEASE READ ALL THE WARNINGS
ON PAGES 2 & 3 BEFORE USING THIS
MARKER
F IG 1B
C
A
D
B
C
D
A
B
FIG 1A
F IG 1B
QUICK SET-UP
8
Etha-Manual-v2.indd 8 13/02/2017 13:10