Manual
THE ON/OFF PURGE SYSTEM
(OOPS)
Having disconnected the macroline hose from the
fitting on the OOPS body, unscrew and remove the
OOPS knob from the OOPS body
(SEE FIGURE
24A)
.
The push rod and o-rings will now be exposed
(SEE
FIGURE 24B)
.Carefully slide the push rod out from
either side of the OOPS body, taking care not to lose
the two o-rings on the push rod
(SEE FIGURE 24C).
Clean off any dirt, debris or moisture from the OOPS
knob and the OOPS body
(SEE FIGURE 24D).
Remove the OOPS insert assembly using a 5/32” hex
key
(SEE FIGURE 25E). Remove the OOPS pin from
the OOPS insert.
Clean and check the condition of the 007 NBR70
o-ring on the outside of the OOPS insert, replacing as
necessary
(SEE FIGURE 25F).
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 24A
FIG 24C
FIG 24E
FIG 24B
FIG 24D
FIG 24F
51
QUICK GUIDE
CONTENTS
INTRODUCTION
QUICK SET-UP
ORIENTATION
USING THE ETHA
USER INTERFACE
MAINTENENANCE
FAULT FINDING
PARTS LIST
SERVICE & SPARES
INDEX
MAINTENANCE
Etha-Manual-v2.indd 51 13/02/2017 13:11