Manual

(CONTINUED)
Using a cotton bud apply a thin film of grease to the
inside of the exhaust port on the bolt guide
1
(SEE
FIGURE 18I)
. Apply grease to the smaller front
o-ring on the valve body
(SEE FIGURE 18J). Then,
being careful not the scratch the inside of the bolt
guide with the firing poppet shaft, slide the valve body
into the bolt guide
(SEE FIGURE 18K) and then
screw the two parts together.
Now apply a thin coat of grease to the three exposed
o-rings on the valve body
(SEE FIGURE 18L),
making sure not to block the gas ports on the valve
body with grease.
Ensure the bumper is facing the correct way on the
bolt guide. The contoured surface should face the bolt
(SEE FIGURE 18M).
Take the bolt and bolt spring and slide them onto the
bolt guide
(SEE FIGURE 18N). The bolt system
assembly has now been fully assembled.
Take the bolt system and insert it into the back of the
Etha body
(SEE FIGURE 18O). Using a 1/4” hex
key, screw the bolt system into the Etha body.
The bolt system has now been lubricated and
assembled.
1
DO NOT apply any grease or oil to the outside of the bolt guide, on
any face of the rear bolt bumper and rear face and internal surfaces
of the bolt.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
F IG 18I
F IG 18K
F IG 18NF IG 18M
F IG 18J
F IG 18L
F IG 18O
43
QUICK GUIDE
CONTENTS
INTRODUCTION
QUICK SET-UP
ORIENTATION
USING THE ETHA
USER INTERFACE
MAINTENENANCE
FAULT FINDING
PARTS LIST
SERVICE & SPARES
INDEX
MAINTENANCE
Etha-Manual-v2.indd 43 13/02/2017 13:11