Manual
ASSEMBLING THE BOLT
SYSTEM
Take the firing poppet and apply a light coating of
grease to the four o-rings on the poppet shaft
(SEE
FIGURE 18A)
. Also apply a light coat of grease
to the shaft itself (
(SEE FIGURE 18B). Before
inserting the firing poppet back into the valve joiner,
apply a light coating of grease to the internal o-ring
and the internal bore of the valve joiner with a cotton
bud
(SEE FIGURE 18C). With the internal bore
of the valve joiner lubricated, hold the valve joiner by
the threads and insert the firing poppet, narrow end
first, into the back of the valve joiner
(SEE FIGURE
18D)
. With the firing poppet pushed all the way in to
the valve joiner, lubricate the external o-rings on the
valve joiner. Be careful not to block the air ports on
the valve joiner with grease
(SEE FIGURE 18E).
Hold the valve joiner upside down and place the poppet
insert into the relief in the back of the firing poppet
(SEE FIGURE 18F). Then slide the valve body over
the valve joiner and firing poppet
(SEE FIGURE
18G)
up to the first set of threads on the valve joiner.
Screw the valve joiner and valve body together
(SEE
FIGURE 18H)
.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
F IG 18 A
F IG 18C
F IG 18E
F IG 18G
F IG 18B
F IG 18D
F IG 18F
F IG 18H
MAIntEnAnCE
42
Etha-Manual-v2.indd 42 13/02/2017 13:11