Manual

(CONTINUED)
Using a dry cotton bud, clean the internal 008 NBR70
o-ring that sits inside the top section of the adjuster
assembly. Then using a small hex key gently apply
Eclipse Grease to the o-ring
(SEE FIGURE 15F)
1
.
At this point if you are maintaining the inline regulator
to fix a supercharging issue, turn to page 38 to the
‘ADVANCED SL3 INLINE REGULATOR MAINTENANCE’
section. If you are not fixing a supercharging issue
then there is no need to perform this advanced
maintenance procedure.
Re-install the adjuster assembly into the bottom
section of the inline regulator threaded end first. Apply
light pressure to the top of the adjuster assembly,
while using a 1/8” hex turn the adjuster screw counter-
clockwise until is stops at the base of the inline
regulator
(SEE FIGURE 15G). Then turn the adjuster
screw back in 2
1/2
turns to set an inline regulator
output pressure that will not damage the marker when
it is ‘gassed up’.
Take the piston, inspect for damage and clean the 016
NBR70 o-ring at the top, re-lubricating it with a light
application of Eclipse Grease
(SEE FIGURE 15H).
Place the inline regulator spring over the piston, then
insert the piston and spring into the top of the inline
regulator top section
(SEE FIGURE 15I)
1
. Holding
the piston and spring in place, screw the top and
bottom sections of the inline regulator together.
Screw the inline regulator onto the Etha body in a
counter-clockwise direction
(SEE FIGURE 15J),
then re-connect the macroline hose to the fitting
on the regulator swivel. Basic cleaning of the inline
regulator is complete.
1
If any o-rings are damaged then replace them. Extra o-rings are
available in parts kits available at www.planeteclipse.com .
THE SPRING IN THE ETHA INLINE REGULATOR HAS
BEEN DESIGNED SPECIFICALLY FOR USE WITH THE
ECLIPSE ETHA. USING ANY OTHER SPRING WILL
DAMAGE THE ETHA AND VOID YOUR WARRANTY.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
F IG 15 E F IG 15 F
F IG 15 H
F IG 15 J
F IG 15 G
F IG 15 I
37
QUICK GUIDE
CONTENTS
INTRODUCTION
QUICK SET-UP
ORIENTATION
USING THE ETHA
USER INTERFACE
MAINTENENANCE
FAULT FINDING
PARTS LIST
SERVICE & SPARES
INDEX
MAINTENANCE
Etha-Manual-v2.indd 37 13/02/2017 13:11