Manual

The remaining set up parameters are used to
configure the performance of the Etha.
DWELL
The Dwell parameter controls the
amount of time that the solenoid
valve is energised and therefore the
amount of gas that is released with
each shot.
The Dwell parameter is indicated
by a purple light on the navigation
console when you are in the set up
mode.
This parameter is fully adjustable
between 4.0ms and 15.0ms in
0.1ms increments.
DEBOUNCE
The Debounce parameter is used
to set the level of Debounce (anti-
trigger bounce) on the Etha.
The Debounce parameter is
indicated by a ‘light blue’ LED on
the navigation console when you are
in the set up mode.
This parameter is fully adjustable
between Debounce 1 and Debounce
10 with a higher value reducing the
amount of trigger bounce.
THE FACTORY
RESET
Whilst in set up mode, it is
possible to reset all of the control
parameters to the factory default
settings in the following way:
1. Push and hold the Tournament
Lock button (see page 29 for
information on the Tournament Lock
button) for two seconds.
2. The LED on the navigation console
will repeatedly flash blue to indicate that the factory
default settings have been restored.
The Etha software parameters and presets are correct at time of printing. However newer versions of the Etha software may have different
parameters and presets to those printed above. Some parameters may have ben added or removed entirely. Please contact your nearest
service centre if you have any queries regarding the Etha software installed in your marker.
33
QUICK GUIDE
CONTENTS
INTRODUCTION
QUICK SET-UP
ORIENTATION
USING THE ETHA
USER INTERFACE
MAINTENENANCE
FAULT FINDING
PARTS LIST
SERVICE & SPARES
INDEX
USER INTERFACE
Etha-Manual-v2.indd 33 13/02/2017 13:10