Manual

ATTACHING A LOADER
Release the clamping lever on the feed neck
(SEE
FIGURE 9A)
and test to see if your loader can easily
be pushed into the top of the feed neck. If the loader
cannot easily be pushed into the feed neck, loosen
the top screw on the feed neck by turning it counter-
clockwise using a 5/32” hex key
(SEE FIGURE 9B).
When you have managed to push your loader into
the feed neck, close the clamping lever to secure it
firmly in place
(SEE FIGURE 9C). If the loader is
loose then you will need to release the clamping lever,
tighten the top screw slightly by turning it clockwise
with a 5/32” hex key
(SEE FIGURE 9B), then close
the clamping lever. Repeat this process as necessary
to secure your loader in place.
You have now attached a loader to your Etha. Once
you have filled your loader and air tank you will then
be ready to begin using your Etha.
DO NOT OVER TIGHTEN THE CLAMPING FEED
NECK AS THIS MAY DAMAGE THE LOADER OR FEED
NECK ITSELF.
FIG 9A
FIG 9B
FIG 9C
USING THE ETHA
24
Etha-Manual-v2.indd 24 13/02/2017 13:10