Manual

SETTING UP THE ETHA
Before you can begin to use your Etha, you will need to
attach a barrel, an air system and a paintball loader.
INSTALLING A BARREL
While pointing the Etha marker in a safe direction,
insert the barrel into the front of the Etha body and
screw the barrel into the Etha (in a counter-clockwise
direction). Continue to screw the barrel into the Etha
body until the barrel becomes tight in the body. DO
NOT over tighten the barrel
(SEE FIGURE 6A).
Install a barrel blocking device over the barrel such as
the Eclipse barrel sock supplied with the Etha
1
(SEE
FIGURE 6B)
. You have now installed the barrel.
T-SLOT MOUNTING SYSTEM
The Etha utilises a T-slot arrangement to mount the
OOPS to the bottom of the frame
A
. There are two
retaining screws on the OOPS body underside
B
.
These are used to clamp the OOPS onto the frame. It
is advisable to make sure that these screws are tight
using a 3/8” hex key before attaching an air system
(SEE FIGURE 6C).
1
Instruction on using the Eclipse barrel sock can be found on the
barrel sock warning label.
A
B
MAKE SURE THE MARKER IS TURNED OFF AND
THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING A BARREL.
FIG 6A
FIG 6B
FIG 6C
USING THE ETHA
20
Etha-Manual-v2.indd 20 13/02/2017 13:10