User Manual

FIG-1
09
ETHA2 PAL
QUICK START
STATUS INDICATOR
CB
FIG-1
The status indicator is visible on each side of the ETHA2 and is used to
indicate a number of dierent things.
Breech sensor status
After power up the ETHA2’s status indicator
C
will display the status
of the breech sensor (BS). The breech sensor (BS) is used to detect
paintballs in the breech of the marker.
To switch the BS on/o hold the On/O button
B
for a second (when the
marker is switched on) until the status indicator
C
changes colour.
The table below shows each LED colour and its relevant BS status.
LED COLOUR BREECH SENSOR (BS) STATUS
FLASHING YELLOW
BS enabled. NO paintball detected.
Marker WILL NOT re.
FLASHING LIGHT BLUE
BS enabled. Paintball detected.
Marker WILL re.
FLASHING PURPLE (SLOW)
BS disabled. Marker WILL re.
FLASHING PURPLE (FAST)
Blockage detected. BS disabled.
Marker WILL re.
RED
Replace battery.
Marker may or may not re.
Battery status
1
Tap the On/O button
B
.
2
The status indicator
C
will indicate the status of the battery for
2 seconds (see the table below for battery status colour information).
LED COLOUR BATTERY STATUS
GREEN Battery level is good.
YELLOW Battery level is low.
RED Replace the battery.
FLASHING RED Insufcient energy, replace battery immediately.
The status indicator also indicates the various marker parameter settings.
See pages 16-17.
WARNING!
When the battery indicator is being displayed the marker is still on and will re if
the trigger is pulled - depending on the BS status.
Do not dry re/shoot the marker without paintballs. Prolonged dry ring may
lead to damage/wear of the internal components of the marker.
WARNING