User Manual

13
ETHA2 PAL
FIG-1
A
Switch the marker o.
B
Ensure that a barrel blocking device is tted for safety.
C
De-gas the marker.
Push and hold the POPS button and pull the POPS switch away
from the POPS body.
D
Remove the Preset air system.
Unscrew the air system counter-clockwise from the POPS body.
E
Loosen the PAL clamping feed neck.
Open the feed neck lever away from the feed neck.
Unscrew the feed neck lever screw counter-clockwise.
F
Remove the loader.
If the feed neck is too tight, loosen the clamping feed neck more.
G
Remove the barrel from the marker body.
Unscrew counter-clockwise to remove.
H
Remove the barrel tip from barrel back.
Unscrew clockwise to remove.
1
IMPORTANT! Take extra precaution to avoid injury.
2
IMPORTANT! To switch On/O, see page 8.
3
IMPORTANT! Always de-gas before unloading.
4
IMPORTANT! Always remove air system before unloading.
5
IMPORTANT! Always remove any paintballs from the breech of the
marker once the loader has been removed.
6
IMPORTANT! Unscrew the barrel tip CLOCKWISE from the back.
QUICK START
UNLOADING THE ETHA2
WARNING!
Always make sure that the marker is o with a barrel blocking device installed
and that no paintballs are in the ETHA2 or loader before unloading.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
NEVER leave the ETHA2 gassed up when unloading.
NEVER point your marker in the direction of other people when not on the eld.
Remove any paintballs from the breech before storing your ETHA2.
WARNING