Manual
07
ETHA2
FIG-1
A
Ensure the marker is switched o before you begin.
B
Screw both ends of the barrel together.
Screw the barrel tip counter-clockwise onto the barrel back.
C
Screw the complete barrel to the marker.
The barrel back screws clockwise into the marker body.
D
Attach barrel blocking device for safety.
E
Ensure the marker is de-gassed.
Push and hold the POPS button and pull the POPS switch away
from the POPS body.
F
Attach the preset air system.
Screw the air system clockwise into the POPS body.
G
Loosen the clamping feed neck.
Open the feed neck lever away from the feed neck.
Unscrew the feed neck lever screw counter-clockwise.
H
Attach the loader.
If the feed neck is too tight, loosen the clamping feed neck more.
I
Secure the loader.
Close the feed neck lever to secure.
Screw the feed neck lever screw clockwise to tighten.
J
Gas the marker.
Push the POPS switch into the POPS body until it engages.
K
Switch on the ETHA2.
1
IMPORTANT! To switch On/O see page 8.
2
DO NOT over-tighten the barrel.
3
IMPORTANT! Always ensure marker is de-gassed when setting up.
4
NEVER use CO2. Only use compressed air or Nitrogen.
5
DO NOT over-tighten the feed neck. This may damage the ETHA2.
QUICK START
SETTING UP THE ETHA2
WARNING!
Always make sure that the marker is o with a barrel blocking device installed
and that no paintballs are in the ETHA2 or loader before installing an air system.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
Only attach an air system certied for use within the country of use.
Never add lubricants or grease into the ll adaptor of the air system regulator.
Ensure that all screws are tightened and no parts are loose before installing an
air system.
Do not pressurise the ETHA2 without the bolt system correctly installed, as high
pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the ETHA2 until
you feel condent with your ability to handle the marker safely and responsibly.
WARNING