Manual

23
ETHA2
FAULT FINDING
FAULT FINDING TABLES
SYMPTOM POSSIBLE CAUSE SOLUTION
Two or more balls are being
fed into the breech.
Worn, damaged or missing ball detents. Change the rubber ball detent.
The feed force too high from loader. Adjust loader settings/use lower force loader.
ETHA2 is inconsistent.
The inline regulator is dirty. Strip and clean inline regulator, replace regulator seal.
The Dwell is too low. Increase the Dwell setting.
Poor quality paintballs. Use better quality paintballs.
Poor paintball size to barrel bore match. Use a closer paintball to barrel bore size.
Inconsistent air supply from air system. Service the air system.
ETHA2 is inefcient. Poor paintball size to barrel bore match Use a closer paintball to barrel bore size.
When the ETHA2 powers up the Status
indicator ashes WHITE or RED.
The trigger is being pulled. Release the trigger before powering on the ETHA2.
Microswitch is permanently depressed by an
incorrectly set trigger.
Adjust the trigger so that when the trigger is at
rest the microswitch is not being activated.
If an issue with the ETHA2 cannot be solved using the fault nding guide, contact your nearest Eclipse Service Centre for assistance.