Manual

(continued)
Remove the Detent and using a dry cotton bud
clean the Detent and its location point in the Etha
body. Inspect the Detent for damage and replace if
necessary
See fiGure 14d)
1
.
Insert the Detent into the Etha body
(See fiGure
14e)
and place the sensor unit back into the
designated slot in the body
(See fiGure 14b).
Ensure that the sensor unit is face down in the body i.e.
looking into the breech
2
.
Replace the BBSS cover, then using a 5/64" hex
key tighten the BBSS cover retaining screw into the
body
(See fiGure 14f. Do not over tighten the
retaining screw.
Repeat the procedure for the opposite side of the
Etha.
You have now cleaned your Break Beam Sensor System.
1
Replace any worn/damaged parts using authentic Eclipse Etha
spare parts.
2
Ensure that the receiver sensor (indicated by red heat shrink
sleeving) is located on the right-hand side of the marker body.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 14d
FIG 14E
FIG 14F
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
35
MAINTENANCE
QUICK GUIDE