Manual

SWITCHING ON THE ETEK5

At the rear of the frame is the navigation console which houses the Select button

(labelled

gure 3A). This button is the disabling device for the ETEK5,

used to switch the marker on and off. Press and hold the Select button .

Release the Select button when the LED lights up and your ETEK5 will begin

its power up sequence.

1,2

SWITCHING OFF THE ETEK5

Press and hold the Select button . Release the Select button when the LED

on the navigation console turns red.

FIRING THE ETEK5

If the Breech Sensor (BS) is disabled, pull the trigger to re the ETEK5. If

the Breech Sensor is enabled and there is a paintball in the breech, pulling

the trigger will also re the ETEK5. The entire ring sequence is controlled

electronically by the ETEK5 circuit board and solenoid, enabling any user to

achieve high rates of re easily.

1 When the ETEK5 is turned on, the Breech Sensor is automatically enabled.

2 The colours displayed during the power up sequence may vary depending on the region the

marker was originally purchased.

USING THE ETEK5

8 ETEK5 MANUAL

FIG 3A