Manual

56 ETEK5 MANUAL
MAINTENANCE
THE ETEK5 ON/OFF PURGE SYSTEM (OOPS)
Having disconnected the macroline hose from the tting on the OOPS body,
unscrew and remove the OOPS knob from the OOPS body (see gure 31A).
The push rod and o-rings will now be exposed (see gure 31B). Carefully slide
the push rod out from either side of the OOPS body, taking care not to lose the
two o-rings on the push rod (see gure 31C).
Clean off any dirt, debris or moisture from the OOPS knob and the OOPS body
(see gure 31D).
Remove the OOPS insert assembly using a 5/32” hex key (see gure 31E).
Remove the OOPS pin from the OOPS insert.
Clean and check the condition of the 007 NBR 70 o-ring on the outside of the
OOPS insert, replacing as necessary (see gure 31F).
FIG 31A
FIG 31C
FIG 31E
FIG 31B
FIG 31D
FIG 31F
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING