Manual

ETEK5 MANUAL 53
MAINTENANCE
MAINTAINING THE VALVE ASSEMBLY
The valve guide should only be removed if the valve guide is damage, causing
a leak down the barrel, feed tube or rammer slot. The valve guide does not
need to be removed for general maintenance.
Lift the bolt pin and slide the bolt assembly out of the rear of the marker
(see gure 30A). Disconnect the macroline, remove the regulator sleeve (see
gure 30B) and unscrew the inline regulator from the FRM as detailed in the SL4
inline regulator section of this maintenance guide (page 39).
Push and hold the front of the LPR assembly and the valve plug back into the
ETEK5 body (see gure 30C). While continuing to do this, pull the tuning fork out
of the ETEK5 body (see gure 30D).
Remove the valve plug with attached valve stem from the ETEK5 body
(see gure 30E). The valve plug and valve stem assembly are one complete unit
(see gure 30G).
WARNING!
Do not push on the rammer housing valve sealing face to remove the
rammer housing from the body. Doing so may cause irreparable damage to
the sealing face.
WARNING
FIG 30A
FIG 30C
FIG 30B
FIG 30D
FIG 30E FIG 30F
12