Manual

ETEK5 MANUAL 49
THE ETEK5 TRIGGER ASSEMBLY
To remove the trigger from the ETEK5, rstly unscrew the four retaining screws
that hold the left and right grip panels onto the frame using a 5/64” hex key
(see gure 28A), then remove the grip panels.
With a 1/16” hex key, loosen the trigger pin retaining screw (see gure 28B).
As the screw is backed out the trigger pin will become free. When the trigger pin
moves freely inside the frame use a small hex key to push the trigger pin out of
the frame (see gure 28C).
With the trigger pin removed, carefully rotate the trigger forwards, and slide it out
of the frame (see gure 28D), making sure not to damage the micro-switch.
The trigger has now been removed for cleaning.
MAINTENANCE
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
FIG 28A
FIG 28B
FIG 28C
FIG 28D