Manual

48 ETEK5 MANUAL
CONTINUED
To re-attach the frame follow the instructions below.
Carefully thread the solenoid and Breech Sensor wires through the access hole in
the top of the ETEK5 (see gure 27E) making sure the wires do not obstruct the
micro switch arm. Re-attach the grip frame to the marker body by tightening the
two grip frame screws using a 1/8” hex key (see gure 27F).
Ensure that the Breech Sensor cables lie neatly in the slots provided for them
on the inside of the ETEK5 grip frame and connect the solenoid and the Breech
Sensors to their relevant connections on the ETEK5 circuit board (see gure 27G).
Re-attach the ETEK5 rubber grips to the frame by using a 5/64” hex key to replace
the four grip screws.
MAINTENANCE
FIG 27E
FIG 27G
FIG 27F