Manual

46 ETEK5 MANUAL
MAINTENANCE
FIG 26E
FIG 26G
FIG 26I
FIG 26F
FIG 26H
CONTINUED
Clean and inspect the rammer bumper inside the rammer cap (labelled
A
gure 26E). If the face of the bumper is damaged or worn then the bumper can
be ipped over to the reverse side and re-inserted. Using a pick or small hex key,
carefully remove the rammer bumper from inside the rammer cap. If both sides
are damaged or worn then replace with a new bumper. The bumper does not
require lubrication.
Clean and inspect the o-ring on the outside of the rammer cap (labelled
B
gure 26E), replacing if the o-ring is damaged. Inspect the internal surfaces of
the rammer cap for debris or dirt, cleaning with a cotton bud if required. Apply a
small amount of grease to the external o-ring on the rammer cap.
Insert the rammer shaft into the ETEK5 body (see gure 26F)
Screw the rammer cap back into the body by hand until it is nger tight
(see gure 26G).
1
Using a hex key push the rammer shaft back into its rearward position (labelled
A
gure 26H), replace the bolt and locate the bolt pin into the designated slot in
the rammer shaft using the marker on the top of the bolt as a position reference
guide (labelled
A
gure 26I).
Incorrect location of the bolt pin can seriously damage the body of your ETEK5.
1 DO NOT over tighten the rammer cap.
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
A
A
A
B