Manual

ETEK5 MANUAL 45

MAINTENANCE

FIG 26CFIG 26B

FIG 26D

MAINTAINING THE RAMMER

Pull the bolt pin upwards

so that it disengages the rammer assembly, allowing

the bolt to be removed

via the rear of the ETEK5 (see gure 26A).

Using a 3/16” hex key, unscrew and remove the rammer cap at the rear of the

ETEK5 (see gure 26B).

Raise the front of the ETEK5 and tap the ETEK5 onto your hand until the rammer

falls into the palm of your hand (see gure 26C).

Thoroughly clean the rammer shaft and all of its o-rings, replacing any o-rings

which appear damaged or worn (labelled

gure 26D). Lubricate all of the

seals on the rammer shaft using Eclipse gun oil, do not use grease on the

rammer as this may cause adverse performance effects.

Replace any worn seals/bumpers using authentic ETEK5 spare parts.

DO NOT use Eclipse Grease on the rammer. Only use light paintgun oil, we

recommend Eclipse Oil.

The number of o-rings on the rammer may vary according to the model of ETEK5

that you have.

A A

FIG 26A