Manual

WARNING!
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
MAINTENANCE
38 ETEK5 MANUAL
CONTINUED
Remove the rubber detent and using a dry cotton bud clean the detent and its
location point in the ETEK5 body, replacing the detent if it is damaged
(see gure 21D).
Reinsert the detent back into the ETEK5 body and place the Breech Sensor back
into the designated slot in the body (see gure 21E). Ensure that the sensor is
face down in the body i.e. looking into the breech.
1
Replace the Breech Sensor cover and using a 5/64” hex key, replace the
retaining screw to hold the eye cover in place (see gure 21F).
Repeat the procedure for the opposite side of the ETEK5.
You have now cleaned your Breech Sensor.
1 Ensure that the receiver sensor (indicated by a red mark & red heat shrink) is located on the
right-hand side of the marker body.
FIG 21D
FIG 21E
FIG 21F