Manual

In depth information covering all
aspects of the ETEK5 OLED Board.
ETEK5 OLED BOARD
ETEK5 MANUAL 29
INSTALLING THE ETEK5 OLED BOARD
Remove the ETEK5 grips by unscrewing the four retaining screws with a 5/64”
hex key (see gure 18A).
Peel the right side of the grip off, exposing the battery. Remove the battery and
unplug the battery from the connector as detailed on page 7.
Turn the marker over and peel the left side of the grip off. The grips can now be
removed.
Unplug the BS, solenoid and microswitch connectors from the ETEK5 circuit
board (see gure 18B).
Remove the ETEK5 logo plate by sliding it out from the guides holding it in place
(see gure 18C). Once removed gently push the circuit board from the right side
out of the left side frame then remove the board (see gure 18D).
Plug the OLED board into the six pin socket on the ETEK5 circuit board as
shown in gure 18E. Make sure the OLED board pins are seated correctly in the
connector (see gure 18F). The OLED board MUST be seated with the pins to
the left of the OLED board NOT to the right (see gure 18G). Incorrect tment of
the OLED board may damage both the ETEK5 and the OLED board and it will not
t in your ETEK5 frame. Gently remove the OLED display’s protective lm using
the green tab (labelled
A
in gure 18F) before installation.
Check that the retainer clip is correctly located in the frame so that you can then
re-install the board with the OLED board attached (see gure 18H) making sure
the button on the circuit board does not jam on the metal push button in the
frame. Tilt the console downwards so that the metal push button slides away from
the circuit board.
Reinstall the battery as detailed on page 7, replacing the right side of the grip
using two retaining screws.
Reconnect the BS, microswitch and solenoid to the circuit board. Then replace
the left side of the grip using two retaining screws.
You have now installed the ETEK5 OLED board.
FIG 18A
FIG 18C
FIG 18E
FIG 18G
FIG 18B
FIG 18D
FIG 18F
FIG 18H
A