Manual

USING THE ETEK5
20 ETEK5 MANUAL
SETTING THE TRIGGER
There are three adjustment points on the trigger – the pre-travel screw, the post-
travel adjuster screw, and the magnet adjuster screw.
As standard each ETEK5 comes with a factory set trigger travel of approximately
2mm in total length; one millimeter of travel before the ring point and one
millimeter of travel after the ring point.
The pre-travel adjuster screw is used to set the amount of trigger travel prior to
the marker ring. Turn this screw clockwise to reduce the amount of travel. Do not
turn the screw too far or the trigger will be pushed past the ring point and the
marker will not work. Turn this screw counter clockwise to increase the amount of
trigger travel (see gure 14A).
The post-travel adjuster screw is used to set the amount of travel after the marker
has red. Turn this screw clockwise to reduce the amount of travel. Do not turn
the screw too far or the trigger will be prevented from reaching its ring point
and the marker will not work. Turn this screw counter clockwise to increase the
amount of travel (see gure 14B).
The magnet adjuster screw is used to adjust the amount of return force with
which the trigger is returned. Turn the screw clockwise to increase the amount
of magnet return force. Do not turn the screw to far or it will negate the position
of the pre-travel adjuster screw. Turn the screw counter clockwise to reduce the
amount of magnet return force (see gure 14C).
FIG 14C
FIG 14B
FIG 14A
+
+
+
_
_
_