Manual

(CONTINUED)
Take the Emortal Board navigation console and peal
off the sticker backing.
(SEE FIGURE 27G)
Making sure the small plastic lens is still in the
window at the bottom of the navigation console, and
the push button strip is still in the back of the frame,
insert the navigation console into the back of the
frame with the window at the bottom.
(SEE FIGURE
27H)
Ensure the circuit board retainers are attached in
the correct orientation to the Emortal board
(SEE
FIGURE 27I).
Then insert the Emortal board into
the frame with the screen at the bottom of the frame.
Connect the BBSS, Solenoid and Trigger connectors to
the circuit board with their corresponding sockets on
the board.
(SEE FIGURE 27j)
Install a 9V battery as described on page 11. (SEE
FIGURE 27K)
Replace the three grip screws using a 5/64” hex key.
(SEE FIGURE 27L)
You have now installed the Etek4 Emortal board.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
FRAME
ETEK4 EMORTAL
BOARD ORIENTATION
FIG 27G
FIG 27I
FIG 27K
FIG 27H
FIG 27J
FIG 27L
76.
UPGRADING