Manual

INSTALLING THE EMORTAL
BOARD (ETEK4 AM FRAMES
ONLY)
Open up the frame by unscrewing the three grip
screws with a 5/64” hex key.
(SEE FIGURE 27A)
Unplug all 3 connectors from the circuit board. (SEE
FIGURE 27B)
Unplug and remove the battery. See page 11 on
‘Installing a 9V Battery’ for instructions on how to do
this.
(SEE FIGURE 27C)
Slide the LED board out of the frame along with the
retainers.
(SEE FIGURE 27D)
Using a hex key or finger push the LED navigation
console out of the frame from the back though the
window in the frame
(SEE FIGURE 27E). Leave the
plastic push button strip in the back of the frame.
(SEE FIGURE 27F)
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
FIG 27A
FIG 27b
FIG 27D
FIG 27F
FIG 27C
FIG 27E
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
75.
UPGRADING
QUICK GUIDE