Manual

(CONTINUED)
Position the trigger so that the hole through the
trigger lines up with the holes in the bearing carrier
(SEE FIGURE 23E).Then slide the trigger pin in
place, tighten the trigger pin locking screw in the back
of the trigger ensuring that the trigger can still move
freely in the bearing carrier.
Gently lower the trigger assembly and bearing carrier
into the frame, taking care not to damage the micro-
switch and ensuring that the trigger is positioned
correctly
(SEE FIGURE 23F). Then insert the
retaining clip into the frame on top of the bearing
carrier, ensuring the legs of the clip are sat in the
locating holes in the frame wall
(SEE FIGURE
23G)
.
You have now stripped and cleaned your Etek4 trigger
assembly.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
FIG 23E
FIG 23F
FIG 23G
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
67.
MAINTENANCE
QUICK GUIDE