Manual

REMOVING AND ATTACHING

THE FRAME

Disconnect any hosing and unscrew the inline

regulator from the front regulator mount as detailed

in the Cleaning the Inline Regulator section of this

maintenance guide (pages 56-57).

Using a 5/64” hex key remove the six screws that

attach the Etek4 rubber grips to the Etek4 grip frame

(SEE FIGURE 22A). Unplug the solenoid

and

break beam sensor system connectors

from the

Etek4 circuit board

(SEE FIGURE 22B).

Using a 1/8” hex key undo the two frame retaining

screws

(SEE FIGURE 22C) and remove the frame

from the Etek4 body, taking care not to damage any

wires

(SEE FIGURE 22D).

You have now removed the frame.

DE-GAS YOUR MARKER, DISCHARGING ANY

STORED GAS IN A SAFE DIRECTION, AND REMOVE

THE BARREL, LOADER, AIR SYSTEM AND ANY

PAINTBALLS TO MAKE THE MARKER EASIER AND

SAFER TO WORK ON.

WARNING

FIG 22A

FIG 22b

FIG 22C

FIG 22D

64.

mAINTENANCE