Manual
RATE
THE LINEAR RAMP RATE PARAMETER
The parameter is only available when
Linear Ramping is selected and is used to
set the percentage increase in rate of fire
over rate of trigger pulls.
For example, if the user is pulling the
trigger at a rate of 10 pulls per second
and the RATE parameter is set to 50%
then the rate of fire is 10 plus 50% extra
which is 15 balls per second.
This parameter can be set between 0 and
100% in 10% increments.
PULL NO
THE RAMP START PARAMETER
The parameter sets the number of trigger
pulls that are required at the KICK IN rate
before ramping will start. The parameter
can be set between 4 and 9 pulls in
increments of 1.
KICK IN
THE RAMP KICK-IN PARAMETER
This parameter sets the minimum rate at
which the user has to pull the trigger in
order to start ramping. This parameter
can be set between 5.0 and 15.0 pulls per
second in 0.1 pulls per second increments.
SUSTAIN
THE SUSTAIN RATE PARAMETER
Once the Etek4 is ramping the user has to
continue to pull the trigger at a minimum
rate in order to maintain the ramping.
This parameter sets this rate and can be
between 5.0 and 15.0 pulls per second in
0.1 pulls per second increments.
RESTART
THE RAMP RESTART PARAMETER
The RESTART parameter defines the
amount of time after the last trigger pull
during which the ramp can be restarted
with a single trigger pull. If a trigger pull
occurs after the RESTART time has expired,
then the other ramp start conditions have
to be met before ramping will restart. This
parameter can be set between 0.0 and 1.0
seconds in 0.1 second increments.
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
51.
EMORTAL BOARD
QUICK GUIDE