Manual
(CONTINUED)
High, mid and low pressure output preset air systems
can be used with the Etek4, providing the Etek4 is
fitted with the SL3 inline regulator originally supplied
with the marker.
The Eclipse Etek4 comes complete with an Eclipse
On/Off Purge System (OOPS) which provides a direct
connection for a preset air system. Before screwing
an air system into the OOPS ensure that the OOPS
knob is fully unscrewed
(SEE FIGURE 9A). In this
position the OOPS is off and will not pressurise the
Etek4 when an air system is screwed into the OOPS.
Lining the threads up correctly between the OOPS and
the air system, screw the air system into the OOPS
until the air system is screwed all the way in and tight
on the OOPS. The air system MUST be screwed all the
way in before turning on the OOPS
(SEE FIGURE
9B)
.
Now with the air system attached and the barrel
pointing away from you, start to slowly turn the OOPS
knob counter-clockwise to turn the OOPS on and
pressurise the Etek4. Keep turning the knob until it
stops against the OOPS body as shown in
FIGURE
9C
.
You have now installed a preset air system onto your
Etek4.
FIG 9A
FIG 9b
FIG 9C
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
23.
USING THE ETEK4
QUICK GUIDE