Manual
SETTING UP THE ETEK4
Before you can begin to use your Etek4, you will need to
attach a barrel, an air system and a paintball loader.
INSTALLING A BARREL
Every Etek4 comes complete with an Eclipse Shaft4
barrel (see page 13).
To install the Shaft4 barrel, firstly screw the barrel tip
and barrel back sections together. The threads on the
Shaft4 barrel tip are reverse threaded, to screw the two
sections together, with the barrel pointing away from
you, turn the barrel tip in a clockwise direction
(SEE
FIGURE 7A)
.
While pointing the Etek4 marker in a safe direction,
insert the assembled Shaft4 barrel into the front of
the Etek4 body and screw the Shaft4 barrel into the
Etek4 (in a counter-clockwise direction). Continue to
screw the Shaft4 barrel into the Etek4 body until the
barrel becomes tight in the body
(SEE FIGURE 7B).
DO NOT over tighten the barrel.
Install a barrel blocking device over the barrel such as
the Eclipse Barrel Sock supplied with the Etek4
1
(SEE
FIGURE 7C)
. You have now installed the barrel.
T-SLOT MOUNTING SYSTEM
The Etek4 utilises a T-slot arrangement to mount the
OOPS to the bottom of the frame
A
. There are two
retaining screws on the OOPS body underside
B
.
These are used to clamp the OOPS onto the frame. It
is advisable to make sure that these screws are tight
using a 3/8” hex key before attaching an air system
(SEE FIGURE 7D).
1
Instruction on using the Eclipse barrel sock can be found on the
barrel sock warning label.
A
B
MAKE SURE THE MARKER IS TURNED OFF AND
THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING A BARREL.
WARNING
FIG 7A
FIG 7b FIG 7C
FIG 7D
20.
USING THE ETEK4