Manual

THE SHAFT4 BARREL
A
B
D
C
The Eclipse Etek4 comes as standard with an
Eclipse Shaft4 barrel
.
1,4
The
barrel screw
s into the front of the Etek4 using a
right hand thread
meaning that
if you hold the Etek4 pointing away from you
the barrel screws into the body i
n a
counter-clockwise direction.
2
T
he barrel comprises of two parts, a barrel back
A
and
a barrel tip
B
. The
two parts are joined together with a
left hand thread
meanin
g that if you hold the
barrel,
with the back sect
ion nearest you, the barrel tip sc
rews in a
clockwise
direction.
On t
he barrel back th
ere is a 016 NBR 70 o-ring
C
which prevents th
e Shaft4
barrel from vibrating loose from the Etek4 body when the marker is fired.
There is also a 016 NBR 70 o-ring on the front of the barrel back
D
helps with
alignment when the two barrel sections are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
1
The bore size of your Shaft4 may vary according to the
model of Etek4 that you have.
2
The Etek4 will only accept COCKER threaded barrels.
Do not use any other type of barrel thread.
3
The Eclipse Shaft4 tip and back barrel sections are not
interchangeable with older version Shaft tip and back
barrel sections (including Shaft3 barrel kits).
4
The model of barrel accompanying your Etek4 may
differ from that stated in this manual.
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
13.
ORIENTATION
QUICK GUIDE