Manual
INSTALLING A 9V BATTERY
Ensure that the Etek4 is switched off. Place the
marker on a flat surface in front of you with the feed
tube furthest away from you and the barrel pointing
to the right.
Using a 5/64” (2mm) hex key, remove the three
countersunk screws that holds the rubber grip onto
the grip frame. Peel the rubber grip to the right to
expose the electronics within the grip frame.
If present, remove the existing 9 volt battery by sliding
your thumb into the recess provided below the battery
and lever the battery gently out of the frame
(SEE
FIGURE 5A)
.
On top of the battery you will see the battery
connector and wire that is used to connect the battery
to the circuit board. Gently separate the battery
connector from the battery, so that the existing
battery can be disposed of accordingly and taking
a new 9 volt Alkaline battery (type PP3, 6LR61,
MN1064)
1
connect it to the battery connector (SEE
FIGURE 5B)
.
The battery will only connect to the battery connector
one way. If you are unsure of how to install a new
battery please contact your nearest Eclipse Service
Centre.
Ensure that all of the wires are within the recess
of the frame and not trapped in micro-switch, then
replace the rubber grip and tighten the countersunk
grip screws using the 5/64
th
(2mm) hex key.
DO NOT OVER-TIGHTEN THE SCREWS.
1
Do not use rechargeable batteries or low quality batteries.
FIG 5A
FIG 5b
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
11.
ORIENTATION
QUICK GUIDE