Manual

USING THE BREAK BEAM
SENSOR SYSTEM
When the Etek3 is powered up, the Break Beam Sensor
System (BBSS) is automatically enabled.
To switch o the Break Beam Sensor System, push and
hold the Select button for 0.5 seconds. The ‘E’ on the
Navigation Console will ash purple indicating that the
Break Beam Sensor System has been disabled.
To switch on the Break Beam Sensor System, push and
hold the Select button for 0.5 seconds. The ‘E’ on
the Navigation Console will ash either yellow (no ball
detected) or light blue (ball detected) indicating that the
Break Beam Sensor System has been enabled.
Additional features of the Etek3 Break Beam Sensor
System are covered in full in the ‘Understanding the BBSS
Operation’ section on Page 26 of this User Manual.
PURPLE LIGHT  BBSS
DISABLED
YELLOW LIGHT  NO
BALL DETECTED
LIGHT BLUE LIGHT 
BALL DETECTED
8.
QUICK SET-UP